Comtech EF Data CDM-700 - Manual (Page 174)

CDM-700 High Speed Satellite Modem Revision 5
Remote Control MN/CDM700.IOM
11–24
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Serial Number N/A 9 bytes Query only.
Used to query the unit 9-digit serial number. Unit returns its S/N in
the form xxxxxxxxx.
Example: SNO=176500143 N/A SNO? SNO=xxxxxxxxx
Temperature N/A 3 bytes Query only.
Unit returns the value of the internal temperature, in the form of
sxxx (ºC).
Example: TMP=+026 N/A TMP? TMP=sxxx
Reboot RBT= 1 byte Command only.
Reboot.
Where n is:
1=System reboot
Example: RBT=1 RBT=
RBT?
RBT*
RBT# N/A RBT=n
Firmware
Revision
Details N/A 1 bytes Command or Query.
Firmware Revision Details
i=Bulk Image (1 or 2)
a=Firmware Image
b=Firmware Revision
c=Firmware Date
Example: FRW?1 (Firmware revision details for bulk image 1) FRW=
FRW?
FRW*
FRW# FRW?i FRW={CR}Boot:{CR}a,
b,c{CR}Bulki:{CR}a,b,c{
CR}a,b,c…
E3/T3/STS1
Mode Select ETS= 3 bytes Command or Query.
Sets the E3/T3/STS1 interface card mode.
s=Interface Slot (1 or 2)
p=Interface Port (1 or 2)
m=Mode
0=E3
1=T3
2=STS1
(Note: Command valid Only with CDI-10 Dual G.703 interface)
Example: ETS=111 (sets Interface 1, Port 1 to T3 mode) ETS=
ETS?
ETS#
ETS* ETS?sp ETS=spm