Comtech EF Data CDM-700 - Manual (Page 173)

CDM-700 High Speed Satellite Modem Revision 5
Remote Control MN/CDM700.IOM
11–23
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Frame Error
Rate N/A 9bytes Query only.
s=Defines which interface slot ( 1 or 2 )
Units returns the value of the calculated estimated Frame Error
Rate(LINK ERRORS/RX PACKETS RECEIVED) in the form a.b
x 10
-c . First three bytes are the value. Last two bytes are the
exponent. Returns 0.0E+00 0r 1.0E+00 if the Gigabit Traffic is
RX PACKETS Received 0..
Example: FER=17.8E-03 (which is Slot One FER= 7.8 x 10
-3 )
Valid for Gigbait Interface Only.
Value is reset to 0.00E+00 if GBEI Statistics Cleared.
N/A FER?s FER=sa.bExcc
Rx BER
Alarm
Threshold
BTH 1bytes Command or Query.
Sets and Returns BerThreshold
a=Ber Threshold
0= NONE
3= 1E10-3
4 =1E10-4
5= 1E10-5
6= 1E10-6
7= 1E10-7
8 =1E10-8
Example BTH=3(Sets Ber Alarm Threshold to 1E10-3) BTH=
BTH?
BTH#
BTH?
BTH = 1E10-3
Returns string of BER Alarm
Threshold
Local/Remote
Status LRS= 1 byte Command or Query.
Local/Remote status, where:
0=Local
1=Serial
2=Reserved
3=Ethernet
Example: LRS=1 (which is Serial Remote) LRS=
LRS?
LRS*
LRS# LRS? LRS=x
Software
Revision N/A 34 bytes Query only.
Unit returns the value of the internal software revision installed in
the unit, in the form of x.x.x
Example: SWR=Boot:1.0.1 Bulk1:1.0.1 Bulk2:1.0.1 N/A SWR? SWR=Boot:x.x.x
Bulk1:x.x.x Bulk2:x.x.x