Comtech EF Data CDM-700 - Manual (Page 161)

CDM-700 High Speed Satellite Modem Revision 5
Remote Control MN/CDM700.IOM
11–11
Parameter
Type
Command
(Instruction
Code and
Qualifier)
Arguments
for Command
or Response
to Query
Description of Arguments
Response to
Command
Query
(Instruction
Code and
Qualifier)
Response to Query
Tx Clock
Invert TCI= 2 bytes Command or Query.
Invert Transmit Clock, where:
s=Defines which interface slot ( 1 or 2 )
x=Invert Transmit Clock, where:
0=Normal
1=Inverted
(Note: Command valid Only with CDI-60 HSSI interface)
Example: TCI = 11 (selects Inverted TX Clock, Slot 1) TCI =
TCI?
TCI *
TCI # TCI?s TCI =sx
(see description of
arguments)
Tx Line Code TLC=
3 bytes Command or Query. (G.703 Parameters)
Tx Line Code, where:
s=Defines which interface slot ( 1 or 2 )
c=Defines which channel ( 1 to 2 )
x=Defines Tx Line Code, where:
0=None ( Valid for E3, T3, and STS-1 )
1=HDB3 (Valid for E3 )
2=B3ZS ( Valid for T3 and STS-1)
(Note: Command valid Only with CDI-10 Dual G.703 interface)
Example: TLC=111 (sets Line Code to HDB3 for interface 1
channel 1) TLC=
TLC?
TLC*
TLC# TLC?sc
TLC=scx
(see description of
arguments)
Tx Carrier
State TXO= 1 byte Command or Query.
Tx Carrier State, where:
0=OFF due to front panel or remote control command
1=ON
2=RTI (receive/transmit inhibit)
3=OFF due to ext H/W Tx Carrier Off command (not a valid
argument when used as a command)
Example: TXO=1 (Tx Carrier ON) TXO=
TXO?
TXO*
TXO# TXO? TXO=x
(see description of
arguments)