Comtech EF Data CDM-700 - Manual (Page 115)

CDM-700 High Speed Satellite Modem Revision 5
Front Panel Operation MN/CDM700.IOM
6–61
6.3.4 (SELECT:) Info
INFO: Rem Tx Rx
1:1 Intfc1 Intfc2
(SELECT:) Info provides the ‘read only’ status windows that display information on the current
modem configurations without risking inadvertent changes. Select Rem, Tx, Rx, 1:1, Intfc1, or
Intfc2 using the
◄ ► arrow keys. Press
ENTER
.
INFO: Æ Rem
Remote M&C: 100BaseTx
010.006.030.139
This display provides the status, as applicable, of the Remote Monitor & Control configuration.
If the modem is in Remote Mode, the physical interface type (RS232, RS485-2W or RS485-4W),
device address and baud rate will be displayed as follows:
Remote M&C: RS232
Address: 0000 9600 Baud
If the modem is in Ethernet Remote Mode, the display will similar to what follows:
Remote M&C: 100BaseTx
IP Addr: 010.006.030.177
INFO: Æ Tx
0000.0000 000.000000 TUR
64 7/8 S -24.9 OF N
This display provides Tx information, similar to what is shown above. The following information
is provided:
Top Line:
Tx Frequency Data Rate
Composite Tx Data Rate
FEC Encoder TUR = Turbo
Bottom line:
Modulation Type
Q
= QPSK, 8=8-PSK, 16=16-QAM, or 64=64-QAM
Code Rate 3/4, 7/8
Scrambler State S = Scrambler On, N = Scrambler Off
Clocking Mode INT = Internal, EXT = External, LOP = Loop
Output Power Level
Tx Output State ON = on, OF = Off, EO = external off
TSI State 1 = Transmit Spectral Inversion on, N = Off