Comtech EF Data CDM-700 - Manual (Page 123)

CDM-700 High Speed Satellite Modem Revision 5
Front Panel Operation MN/CDM700.IOM
6–69
If Firmware Images: Select is selected:
Current Active Image: #2
Next Reboot Image: #1 #2
This menu is used to select the active software image. The top line shows the active image. On the
second line, select the desired image using the W X arrow keys, then press
ENTER
. To make the
selected image active, it is necessary to power cycle the modem to reboot the new software.
UTIL:
Æ FAST
FAST:Cnfg View (H/W 0.03)
MainBoard S/N: 123456789
Comtech EF Data’s FAST (Fully Accessible System Topology) system permits the purchase and
installation of options through special authorization codes, entered remotely or through the front
panel. FAST allows immediate implementation of different options through the user interface
keypad. All FAST options are available through the basic platform unit.
In addition, the Hardware Revision Number, and the Main Board Serial Number are presented. This
Serial Number is a unique indentifier for the FAST upgrade process (and is different from the Chassis
Serial Number) and is required to obtain a new FAST code from the factory.
Select either Cnfg or View using the W X arrow keys, then press
ENTER
.
If (UTIL:) FAST: Æ Cnfg is selected:
FAST Configuration
Edit Code Demo Mode
Select Edit Code or Demo Mode using the W X arrow keys, then press
ENTER
.
If FAST Configuration: Æ Edit Code is selected:
Edit 20 digit FAST Code:
00000000000000000000 ENT
Enter the code carefully on the bottom line by using the ◄ ► arrow keys to move to each
character position, then editing the character in that position by using the ST arrow keys. Once
the 20-digit FAST Code has been correctly edited into place, press
ENTER
. The CDM-700 will
respond with “Configured Successfully” if the new FAST option has been accepted.
If FAST Configuration: Æ Demo Mode is selected:
FAST Demo Mode: Off On
604669 seconds remain
The Demo Mode enables all FAST options for seven days (604800 seconds).