Comtech EF Data CDM-700 - Manual (Page 119)

CDM-700 High Speed Satellite Modem Revision 5
Front Panel Operation MN/CDM700.IOM
6–65
If the selected location does not contain a previously stored configuration, the following screen is
displayed:
New Config has been
Saved to Loc 9 (E)
However, if the selected location does contain a previously stored configuration, the following
screen is displayed:
Loc 0 Contains Data !
Overwrite? NO YES (E)
Select No or Yes using the ◄ ► arrow keys, then press
ENTER
. Selecting Yes overwrites the
existing configuration at the selected location.
Save/Load Configuration: ÆLoad
Load Config from Loc: 9
11:02:43 05/08/05 (
ST E)
Using Loc: 9 as the example, if Load is selected and there is a configuration stored at the
selected location, what displays is similar to the preceding example. Note that the stored
configuration is identified with a date and time stamp.
If the selected location contains no data, what displays is similar to the next example:
Load Config from Loc: 9
Empty
( ST E)
Select the location from where the current configuration is to be loaded using the ST arrow
keys, then press
ENTER
. Locations 1 through 10 are available.
If the selected location contains valid data, what displays is similar to the following example:
New Config has been
Loaded from Loc # (E)
Press ENTER or
CLEAR
to return back to the previous menu.
If the selected location contains invalid data, what displays is similar to the next example:
Warning! Loc 9 Contains
No Data! (E)
Press ENTER or
CLEAR
to return back to the previous menu.