BECKHOFF AX5000 S-IDN Parameters - Manual (Page 176)

S­IDNs
S­0­0410 Probe 1 negative latched (Counter)
This parameter indicates whether a positive edge occurred at Probe 1.
Attributes
Name Value
Format binary
Data length 16
Decimal point 0
Min value ­
Max value ­
Default value ­
Unit ­
Changeable in EtherCAT state No
Cyclic transfer AT
Device parameter No
Related to interface revision No
This parameter can be assigned an IDN, so that a real­time status bit can be assigned to this parameter. The
drive only sets bit 0 of this parameter if the command S­0­0170 is enabled, S­0­0405 is set to 1, and the
negative edge of S­0­0401 is enabled.
If a negative edge occurs at the input, the drive saves the parameterised source value in S­0­0131. The drive
resets this bit, if the controller cancels the command S­0­0170, or if S­0­0405 is reset to 0.
Bit pattern:
Bit Meaning
0 Probe 1
Probe 1
0 = not enabled
1 = enabled
1 – 15 Reserved
Note
IDNs involved
S‐0‐0131 [ } 105], S‐0‐0170 [ } 124], S‐0‐0179 [ } 125], S‐0‐0305 [ } 156], S‐0‐0405 [ } 173]
Note
Additional functional description
AX5000 / Probe unit
Single mode
S­0­0409 Probe 1 negative latched / Single mode
Format Size in bit Offset Properties
Enum 16 0 ­­­
AX5000 ­ IDN­Descriptions 176 Version 3.1