Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (January 2015) - Manual (Page 91)

BIOS
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54H) 91
4.2.2.1 Boot Configuration
The table below lists the Boot Configuration options.
SMBIOS Event Log Set SMBIOS configuration. See section SMBIOS Event Log .
Table 4-7 Advanced Menu (continued)
Field Description
Table 4-8 Boot Configuration
Field Description
System Reset Type Enable Warm Reset support, which controls next reset type. Set to
"Cold Reset", to change next reset type to cold reset; Set to "Warm
Reset", to change next reset type to warm reset.
Options: Warm Reset and Cold Reset.
Default is Warm Reset.
Warm Reset Counter Sets the default value of Warm Reset Counter. Range: 0 ~ 65535.
Default is 5.
RPB Terminal Type Emulation: ANSI: Extended ASCII char set.
VT100: ASCII char set.
VT100+: Extends VT100 to support color, function keys, etc.
UTF8: Uses UTF8 encoding to map Unicode chars onto 1 or more
bytes.
Options: ANSI, VT100, VT100+ and UTF8.
Default is VT100.
RPB Baud rate Selects serial port transmission speed. The speed must be
matched on the other side. Long or noisy lines may require lower
speeds.
Options: 9600, 19200, 38400, 57600 and 115200.
Default is 9600.
Front Network Boot Controls execution of the Option ROM for the Front Panel Ethernet
controller.
Options: Disabled and Enabled.
Default is Disabled.