Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (January 2015) - Manual (Page 216)

Supported IPMI Commands
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54H) 216
8.4.5 Set Debug Level Command
The Set Debug Level command sets the current debug level of the IPMC firmware.
Table 8-39 Set Debug Level Command
Type Byte Data Field
Request Data 1:3 PPS IANA Private Enterprise ID
0x00400A = 16394 (Pigeon Point Systems)
LSB byte first: byte 1 = 0A, byte 2 = 40, byte 3 = 00
4 Bit [7] IPMB-L Dump Enable
If set to "1", the IPMC provides a trace of IPMB-L messages
that are arriving to/going from the IPMC via IPMB-L.
Bit [6] n/a
Bit [5] KCS Dump Enable
If set to "1", the IPMC provides a trace of KCS messages
that are arriving to/going from the IPMC via KCS.
Bit [4] IPMB Dump Enable
If set to "1", the IPMC provides a trace of IPMB messages
that are arriving to/going from the IPMC via IPMB-O.
Bit [3] n/a
Bit [2] Alert Logging Enable
If set to "1", the IPMC outputs important alert messages
onto the serial debug interface.
Bit [1] Low-level Error Logging Enable
If set to "1", the IPMC outputs low-level error/diagnostic
messages onto the serial debug interface.
Bit [0] Error Logging Enable
If set to "1", the IPMC outputs error/diagnostic messages
onto the serial debug interface.
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID
0x00400A = 16394 (Pigeon Point Systems)
LSB byte first: byte 2 = 0A, byte 3 = 40, byte 4 = 00