Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (January 2015) - Manual (Page 55)

Hardware Preparation and Installation
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54H) 55
Installation Procedure
To install a DIMM module:
1. Remove the blade from the system as described in Installing and Removing the Blade on page
59 .
2. Open locks of memory module socket.
3. Insert the module carefully into the socket.
As soon as the memory module has been fully inserted, the locks automatically close.
4. If applicable, repeat steps 2 to 3 to install further modules.
Removal Procedure
To remove a DIMM module:
1. Remove the blade from the system as described in Installing and Removing the Blade on page
59 .
2. Open the locks of the socket at both sides.The memory module is automatically lifted up.
3. Remove the module from the socket.
4. Repeat steps 2 to 3 in order to remove further memory modules.
Damage of Circuits
Electrostatic discharge and incorrect module installation and removal can damage circuits
or shorten its life.
Before touching the module or electronic components, make sure that you are working in
an ESD-safe environment.