2 using ipmitool – Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (January 2015) User Manual

Page 179

Serial Over LAN

ATCA-7370/ATCA-7370-S Installation and Use (6806800P54H)

179

Sample Procedure

To set the IP address, proceed as follows:

1. Establish an IPMI connection to the blade.

2. Set LAN Configuration Parameter Set In Progress Lock.

ipmicmd -k "f 0 c 1 1 0 1" smi 0

3. Set LAN Configuration Parameter Set IP (172.16.10.11 on channel 1).

ipmicmd -k "f 0 c 1 1 3 ac 10 0a dd" smi 0

4. Set LAN Configuration Parameter Set In Progress Commit.

ipmicmd -k "f 0 c 1 1 0 2" smi 0

7.3.2

Using ipmitool

The example below shows how to setup a LAN configuration parameter for a potential SOL
session with ipmitool for base 1 (channel 1).

n0s70:~ #

ipmitool lan set 1 ipaddr 172.16.0.221

Setting LAN IP Address to 172.16.0.221

n0s70:~ #

The following example shows how to query the LAN parameters that are currently in use for a
potential SOL session for base 1(channel 1) and base 2(channel 2):

root@localhost:~# ipmitool lan print 1

Set in Progress : Set Complete

Auth Type Support :

Auth Type Enable : Callback :

: User :

: Operator :

: Admin :