Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (January 2015) - Manual (Page 200)

Supported IPMI Commands
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54H) 200
8.3 Artesyn Embedded Technologies Specific
Commands
The Artesyn Embedded Technologies IPMC supports several commands which are not defined
in the IPMI or PICMG 3.0 specification but are introduced by Artesyn Embedded Technologies:
serial output commands.
8.3.1 Set/Get Feature Configuration Commands
This command can be used to enable/disable features within the IPMC during runtime.
 Before sending any of these commands, the shelf management software must check
whether the receiving IPMI controller supports Artesyn Embedded Technologies specific
IPMI commands by using the IPMI command 'Get Device ID'. Sending Artesyn Embedded
Technologies specific commands to IPMI controllers which do not support these IPMI
commands will lead to no or undefined results.
 Proper handling of these commands is required to write a portable application.
Table 8-20 Set/Get Feature Configuration Commands
Command Name
NetFn
(Request/Response)
CMD
Set Feature Configuration 0x2E/0x2F 0x1E
Get Feature Configuration 0x2E/0x2F 0x1F