Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (January 2015) - Manual (Page 75)

Chapter 4
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54H) 75
BIOS
4.1 Features
The Basic Input/Output System (BIOS) provides an interface between the operating system
and the hardware of the blade. It is used for hardware configuration. Before loading the
operating system, BIOS performs basic hardware test, known as Power-On Self Tests (POST)
and prepares the blade for the initial boot-up procedure.
During blade production, identical BIOS images are programmed into both boot flash banks. It
is possible to select boot flash as device to boot from. You can do this via an IPMI command. For
further details refer
Chapter 8, Supported IPMI Commands, on page 183 .
The BIOS used on the blade is based on the Phoenix UEFI BIOS with several Artesyn extensions
integrated. Its main features are as follows:
 Initialize CPU, chipset and memory
 Initialize PCI devices
 Setup utility for setting configuration data
 IPMC support
 Serial console redirection for remote blade access
 Boot operation system
The BIOS complies with the following specifications:
 UEFI Specification 2.0
 Plug and Play BIOS Specification 1.0A
 PCI BIOS Specification 2.1
 System Management BIOS (SMBIOS) Specification 2.3
 BIOS Boot Specification 1.01
 PXE 2.1