Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (January 2015) - Manual (Page 194)

Supported IPMI Commands
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54H) 194
The following table lists the boot parameters that can be configured for the ATCA-7370 blade
using the system boot option parameter #100.
Artesyn Embedded Technologies provides the tool “named ipmibpar”, which is included in the
BBS, to interpret the boot options stored in the IPMC.
1 Completion Code. Generic plus the
following command-specific completion
codes:
80h = parameter not supported
2 [7:4] - reserved
[3:0] - parameter version. 1h is returned.
3 Parameter Valid
[7] - 1b = the storage area is locked.
0b = the storage area is unlocked
[6:0] - parameter selector (must be 100).
4 .. 19 Boot Option Data
Table 8-14 System Boot Options Parameter #100 - GET Command Usage (continued)
Byte Description
To detect the size of the whole storage area, a series of read commands can be issued with
the block selector in 1 increment. Once the error code C9 is returned, the limit has been
reached and the total available space of the storage area can be determined by the block
selector of the last issued command.
This is supported by HPI, for details refer to the System Management Interface Based on HPI-B
User’s Guide related to your system environment.
The boot parameters and their values mentioned here are all case-sensitive.
All boot options listed in the following table are set by the BIOS setup menu and can be
configured using the System Boot options command #100. The IPMC and BIOS software
automatically synchronize the settings made in the BIOS setup menu and the settings
specified using the System Boot Options command #100. Changing a parameter in either of
these, automatically changes the respective value in the other.