Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (January 2015) - Manual (Page 81)

BIOS
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54H) 81
The ATCA-7370 supports four SAS ports. Two local SAS ports are located in the RTM module,
the other two SAS ports are connected to the external ports of the RTM. The SAS physical port
number is assigned as follows:
 P0 - Local SAS 1 which is far from RTM zone 3 connector
 P1 - Local SAS 2 which is near from RTM zone 3 connector
 P2 - External SAS 1
 P3 - External SAS 2
The BIOS and Linux follow the SAS port physical number to assign sequence number. For
example, BIOS and Linux will assign sequence number as following:
4.1.6.2 Network Boot
The BIOS contains a classic PXE Option ROM (OpROMs).
The following table summarizes the network boot support status:
Physical port BIOS Linux
P0 SAS0 sda
P1 SAS1 sdb
P2 SAS2 sdc
P3 SAS3 sdd
Table 4-1 Network Boot Support Status
Ethernet Interface
PXE Boot
Support
Base Network Interface 1 (i350 - 1) Yes
Base Network Interface 2 (i350 - 2) Yes
Front Panel Network Interface (i350 - 3) Yes
Update Channel Network Interface (i350 - 4) No
Fabric Network Interface 1 (82599EB - 1) Yes
Fabric Network Interface 2(82599EB - 2) Yes