Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (January 2015) - Manual (Page 187)

Supported IPMI Commands
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54H) 187
8.1.7.1 System Boot Options Commands
The system boot options commands allow you to control the boot process of a blade by setting
boot parameters of the blade’s boot firmware (BIOS). The boot firmware interprets the boot
parameters and executes the boot process accordingly. Each boot parameter addresses a
particular functionality and consists of one or more bytes. The parameters 0 to 7 are standard
parameters defined by the IPMI specification. The And parameters, 96 to 127 are OEM-specific.
When using the Get/Set System Boot Options command with parameter selector of 96/97/98,
the Set Selector and the Block Selector should be set to 0x00. When using the Get/Set System
Boot Options command with parameter selector of 100, the Set Selector and the Block
Selector have a specific meaning. Details are given in
System Boot Options Parameter #100 on
page 190 for details.
The following table lists which boot properties can be configured and the corresponding boot
parameter number.
Table 8-8 Configurable System Boot Option Parameters
Configurable Boot Property
Corresponding
Boot
Parameter
Number
Selection between BIOS and FPGA boot
96
POST Type 97
Timeout for graceful shutdown 98
BIOS boot parameters 100