4 establishing a sol session – Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (January 2015) User Manual
Page 181
Serial Over LAN
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54H)
181
RMCP+ Cipher Suites : 1,2,3,3
Cipher Suite Priv Max : Not Available
root@localhost:~#
7.4
Establishing a SOL Session
To start a SOL session, the following requirements must be fulfilled:
An Ethernet LAN connection to the on-board Gigabit Ethernet controller of the ATCA-7370
must exist.
The ATCA-7370 IPMC firmware must correspond to version 2.0.1 and above.
Procedure
To establish a SOL session, proceed as follows:
1. Make sure that the requirements detailed above are fulfilled.
2. Compile and install the ipmitool on your target which is destined for opening the
SOL session on the ATCA-7370. For details refer to
.
3. Apply an IP address to the ATCA-7370 SOL interface. For details refer to
4. If necessary change user and password.
Default user is "soluser" and password is "solpasswd".
5. Configure the network between the ATCA-7370 and your target, which is destined
for opening the SOL session, so that the SOL IP address is accessible.
MAC Address 00:00:00:00:00:00 means the address is shared between base and SOL
interface. The address can be found out in the MAC address record of the FRU.