Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (January 2015) - Manual (Page 218)

Supported IPMI Commands
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54H) 218
8.4.8 Get Handle Switch Command
The Get Handle Switch command reads the state of the hot-swap handle of the IPMC.
Overriding of the handle switch state is allowed only if the IPMC operates in (manual)
standalone mode (for a description refer to
Table 8-34 ).
2:4 PPS IANA Private Enterprise ID
0x00400A = 16394 (Pigeon Point Systems)
LSB Byte first: byte 2 = 0A, byte 3 = 40, byte 4 = 00
Table 8-41 Set Hardware Address Command (continued)
Type Byte Data Field
Table 8-42 Get Handle Switch Command
Type Byte Data Field
Request Data 1:3 PPS IANA Private Enterprise ID
0x00400A = 16394 (Pigeon Point Systems)
LSB Byte first: byte 1 = 0A, byte 2 = 40, byte 3 = 00
4 FRU ID (specify as 0)
Response Data 1 Completion Code
2:4 PPS IANA Private Enterprise ID
0x00400A = 16394 (Pigeon Point Systems)
LSB Byte first: byte 2 = 0A, byte 3 = 40, byte 4 = 00
5 Handle Switch Status
0x00: The handle switch is open.
0x01: The handle switch is closed.
0x02: The handle switch state is read from hardware.