Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (January 2015) - Manual (Page 80)

BIOS
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54H) 80
4.1.6 Boot Options
The ATCA-7370 supports the BIOS Boot Specification 1.01. The BIOS identifies all IPL (BAID,
BEV) devices and BCV devices (hard drives, USB sticks) in the system and will attempt to boot
them in the order specified in startup.
The following boot devices are integrated in the BIOS:
 USB devices (sticks, hard drives, CD-ROM)
 Network (BEV)
 SAS HDD connected to C604 chipset
 SATA connected to C604 chipset
 EFI Shell
The default boot order is as follows:
 Attached USB CD-ROM
 Attached USB devices on the external USB port
 SAS HDD
 SATA HDD
 Base Ethernet Interfaces
If the BIOS does not find any ready bootable device, it will loop on the source list until a boot
device becomes ready. After 10 loops, the BIOS initiates a cold reset and retries again or when
configured the BMC watchdog.
The BIOS organizes the devices in groups: CD-ROM, HDD, network, floppy, SAS HDD. Any
device can be set as the first boot device by raising it to the first boot device of its device group,
then raising that group to the first boot group.
The boot order for a certain device and its device group can be set even in the absence of that
device. The order is preserved. When the device is added later, it will be available at the
specified boot order.
4.1.6.1 Boot Support for the SAS Controller
The BIOS contains an option ROM SAS controller on the payload. Supports Legacy boot from
SAS HDDs.