Artesyn ATCA 7370 / ATCA 7370-S Installation and Use (January 2015) - Manual (Page 193)

Supported IPMI Commands
ATCA-7370/ATCA-7370-S Installation and Use (6806800P54H) 193
3 Block Selector
Offset into the storage area of the boot
options in multiples of 16 bytes.
4 .. n (n <= 19) Boot Options Data to be written.
Should not exceed 16 bytes to be written at
a time.
Response Data
1 Completion Code. Generic plus the
following command-specific completion
codes:
80h = parameter not supported
81h = storage area is locked by another
software entity
82h = illegal write-access
Table 8-14 System Boot Options Parameter #100 - GET Command Usage
Byte Description
Request Data
1 Parameter Selector
[7] - reserved
[6:0] - parameter selector (must be 100).
2 Set Selector
0h = user area
1h = default area
All other values are reserved.
3 Block Selector
Offset into the storage area of the boot
options in multiples of 16 bytes.
Response Data
Table 8-13 System Boot Options Parameter #100 - SET Command Usage (continued)
Byte Description