AMETEK Lx Series II - Manual (Page 91)

User Manual Lx / Ls Series II
87
ENTRY DESCRIPTION
never visible due to the maximum number of LCD
characters per line.
Note: If the MAC Address displayed is corrupted or
does not match the serial tag, there may have been a
problem retrieving the LAN port settings. This can
happen if a static IP was set that conflicts with
another device on the network. To recover, turn on
power to the unit while holding down the SET key.
This will allow the unit to boot without attempting to
collect the IP settings. You can then set the required
IP values. [See IP Address above].
GWAddress Gateway address setting. A default gateway is a
node (a router) on a computer network that serves
as an access point to another network.
This value can be changed by pressing the SET
key and entering a new value from the keypad or
using the Voltage and Frequency shuttles. Use the
numeric data pad or the Voltage shuttle to enter
each field. To move between the four fields, use the
decimal point key on the keypad or the Frequency
shuttle.
Any change to this value will NOT take effect until
after power on the unit has been cycled.
HostBits Number of host bits as opposed to network bits in
network mask. A CIDR class C network uses 24
network bits and 8 host bits. (Class A = 24, Class B
= 16).
This value can be changed by pressing the SET
key and entering a new value from the keypad. Any
change to this value will NOT take effect until after
power on the unit has been cycled.
Port No TCP remote port number. This value must be set to
5025 (SCPI) to support the built in web page.
This value can be changed by pressing the SET
key and entering a new value from the keypad. Any
change to this value will NOT take effect until after
power on the unit has been cycled.
LAN Default LAN default setting can be achieve by selecting the
Mac address screen and press the set key followed
by the Enter key. Press the Enter key again to
confirm. The IP address is set to DHCP or AUTO
IP.