AMETEK Lx Series II - Manual (Page 220)

User Manual Lx / Ls Series II
216
Number Message String Cause Remedy
-311 "Memory error" Waveform memory
checksum error. May be the result of incomplete user-
defined waveform download. Check
interface and try downloading
waveform again. Successful download
may clear this error condition.
Alternatively, use TRAC:DEL:ALL
command to clear waveform memory.
-314 "Save/recall memory
lost" User setup register
contents lost Store setup in same register again.
-315 "Configuration memory
lost" Hardware
configuration settings
lost. Contact AMETEK service department
at
[email protected]
to obtain instructions on restoring
configuration data.
-330 "Self-test failed" Internal error Contact AMETEK service department
at
[email protected]
-350 "Queue overflow" Message queue full. Too many message. Read status
using SYST:ERR query until 0, "No
Error" is received indicating queue
empty.
-400 "Query error" Unable to complete
query. Check programming manual for
correct query format and parameters
-410 "Query INTERRUPTED" Query issued but
response not read. Check application program for correct
flow. Response must be read after
each query to avoid this error.
-420 "Query
UNTERMINATED" Query incomplete. Check for terminator after query
command.
-430 "Query DEADLOCKED" Query cannot be
completed Check application program for multiple
queries
-440 "Query
UNTERMINATED" Query incomplete. Check for terminator after query
command.
0 "No error" No errors in queue
2 " Non-volatile RAM
CONFIG section
checksum failed" Controller failure
during Self-test. Contact AMETEK service department
at
[email protected]
3 " Non-volatile RAM CAL
section checksum failed" Controller failure
during Self-test. Contact AMETEK service department
at
[email protected]
4 " Non-volatile RAM
WAVEFORM section
checksum failed" Controller failure
during Self-test. Contact AMETEK service department
at
[email protected]
10 "Ram self test Controller failure
during Self-test. Contact AMETEK service department
at
[email protected]
40 "Voltage self test error,
output 1 No. 1/A amplifier in
Master source has no
output during Self-
test. Contact AMETEK service department
at
[email protected]
41 "Voltage self test error,
output 2 No. 2/B amplifier in
Master source has no
output during Self-
test Contact AMETEK service department
at
[email protected]
42 "Voltage self test error,
output 3 No. 3/C amplifier in
Master source has no
output during Self- Contact AMETEK service department
at
[email protected]