AMETEK Lx Series II - Manual (Page 207)

User Manual Lx / Ls Series II
203
11.8.2 LxGui MS704 Test Screen
The –704F option interface screen is shown below. (Figure 11-13). Settings can be made
through a series of tabbed dialogs in the center of the screen. Any EUT information can be
entered at the bottom. This information will be transferred to the test report.
Test execution is controlled using the Start / Abort buttons to the left. The right hand side of this
window provides output monitoring for voltage (all three phases in 3 phase mode) and frequency.
During a test run, this data is updated once a second. A log of readings is automatically kept.
Figure 11-13: LxGui MS704 Option Screen
All test selection and execution modes are set from this screen.