AMETEK Lx Series II - Manual (Page 143)

User Manual Lx / Ls Series II
139
9. Option
–160: RTCA/DO-160 Rev E Tests (Software)
Use of this option requires the following:
Lx/Ls Series
1
Power Source.
-160 option. Options installed are listed on unit‟s serial tag or shown on Configuration
screen.
Windows XP/2000 PC with RS232C, LAN or National Instruments GPIB controller
interface. AMETEK recommends the use of the GPIB interface for best performance.
LxGui Windows software revision 1.14 or higher. Provided on CI P/N CIC496 CD ROM
or available for download from the AMETEK Programmable Power website.
For specific tests, additional test equipment may be required to perform all section 16
tests.
Refer to the Avionics Software user manual (CI P/N 4994-971) for operating instructions for all
GUI based test options. This manual is distributed in PFD format on the same CD as this user
manual. (CI P/N CIC496).
1
Note: This DO160 Rev E implementation uses arbitrary waveform capabilities and harmonic measurements, both
of which require the –ADV (advanced features) option on the Ls Series. These capabilities are standard on the Lx
Series. Contact California Instruments for information on upgrading Ls Series models with the –ADV option.