Adept s650HS Quattro - Manual (Page 186)

Chapter 10: Robot Cleaning/ Environmental Concerns- H
Figure 10-3. Bottom of Cable Entry Top Cover, CF Frame
3. Adapt Roxtec modules to fit the cables that will be used by peeling out half-circle strips
from the modules. There should be a 0.1 to 1.0 mm gap between the halves of the
modules for a proper seal. See the following figure.
Figure 10-4. Adapting a Module to the Cable Size, Checking the Gap
4. Grease the Roxtec modules, using Roxtec grease. See the following figure.
Adept Quattro User's Guide, Rev F
Page 186 of 196