Adept s650HS Quattro - Manual (Page 152)

Chapter 8: Maintenance - H
Figure 8-14. Squeezing the Horseshoe into Position
Installing Springs on a Horseshoe
1. Slip the spring onto the horseshoe at 90° from its normal position. Refer to the figures in
Removing Outer Arm Springs on page 149.
The narrowest part of the horseshoe is 90° from the groove in which the spring end
normally rests.
2. Repeat for the remaining spring.
Installing the last spring is the most difficult, as the other spring will tend to keep the
spring from moving.
Adept Quattro User's Guide, Rev F
Page 152 of 196