Altera 10-Gbps Ethernet MAC MegaCore Function User Manual
Page 48
Chapter 5: 1G/10GbE MAC Design Example
5–3
1G/10GbE Design Example Components
February 2014
Altera Corporation
10-Gbps Ethernet MAC MegaCore Function User Guide
shows the clocking scheme for the design example.
The 1G/10GbE design example comprises the following components:
■
1G/10GbE Ethernet MAC—the MAC IP core with default settings. This IP core
includes memory-based statistics counters.
■
Backplane Ethernet 10GBASE-KR PHY—the PHY IP core operating as either
1000BASE-X PHY or 10GBASE-R PHY.
■
Reconfiguration Bundle—comprises the reconfiguration controller that switches
the speed between 1 Gbps and 10 Gbps, and the management ROM that stores
MIF information for 1/10GbE PHY or HSSI or hard PCS. This block arbitrates the
access to the reconfiguration controller and requests the reconfiguration controller
to start streaming MIF information.
■
Single-Clock FIFO—Avalon-ST Single-Clock RX and TX FIFO cores that buffer
receive and transmit data between the MAC and the client. These FIFO buffers are
64 bits wide and 2048 bits deep. The Single-Clock FIFO operates in store and
forward mode, and you can configure it to provide packet-based flushing when an
error occurs.
Figure 5–2. 1G/10GbE Design Example Clocking Scheme
Single-Clock
FIFO
Single-Clock
FIFO
PLL
JTAG to Avalon
Master Bridge
Pipeline
Bridge
10GBASE-KR
PHY
1G/10GbE
MAC
Configure
Reconfig
gmii_rx_clk
gmii_tx_clk
rx_coreclkin_1g
rx_clkout_1g
xgmii_rx_clk
tx_clkout_1g
xgmii_tx_clk
tx_coreclkin_1g
rx_clk
ref clk
322.265625
ref clk
125
mm clk
100
tx_clk
125 Mhz
125 Mhz
156.25 Mhz
Reconfiguration
Bundle
PHY IP
Reset Controller