Kipp&Zonen COMBILOG Data Logger - Manual (Page 66)

Setting of the Automatic Switch Off and the
LED Display
Configuration menu
Note: With the automatic switch off function the data logger
can be set to the saving mode if no operation is made by the
press/ rotary knob in a certain time interval (30 seconds). In
this case the display will be set off until a further operation
takes place.
If “LEDs“ is set to ON the LED-display is switched on and the
two LEDs RUN and ERR on the front of the data logger show
the actual operating state (mode) of the data logger. With the
selection OFF the LEDs will be switched off.
Hardware Manual COMBILOG 1022 66