Kipp&Zonen COMBILOG Data Logger - Manual (Page 65)

Setting the scan rate and the averaging interval
Configuration menu
Note: The scan rate determines after which time interval the
measured values of the channels will be measured again. Scan
rate is selectable between 0.5 s and 1 h.
At “Averaging“ the averaging interval can be set. It determines
the time interval for the averaging of the measured values. Av-
eraging interval is selectable between 1s and 12h.
In the example the measured values will be measured again
every 10 seconds and after 60 seconds the average value will
be calculated (here by means of 6 measured values).
Hardware Manual COMBILOG 1022
65