Kipp&Zonen COMBILOG Data Logger - Manual (Page 125)

device identification length = 32 byte
binary (hex 0A) 1 byte
binary (hex 08) 1 byte
binary (hex 05) 1 byte
binary (hex 05) 1 byte
ASCII ("Friedrichs") 10 byte
ASCII ("COMBILOG") 8 byte
ASCII ("xy.yy") 5 byte
ASCII ("xy.yy") 5 byte
x … “V“ : universal program
y.yy : version
device information length = 27 byte
ASCII 20 byte
ASCII 6 byte
binary 1 byte
status information length 6 byte
binary 4 byte
binary 2 byte
= K32..K25 K24..K17 K16..K9 K8..K1
Byte 1 Byte 2 Byte 3 Byte 4
= M16..M9 M8..M1
Byte 5 Byte 6
If the bit Kn in the channel status is set it indicates that an error
has occurred in channel n. A channel error is given when the
measuring value is outside of the linearisation, e.g. in case of a
sensor break down or of a short circuit of transmission.
If a bit in the module status is set it indicates that an error has
occurred in the data logger. Valid is:
Hardware Manual COMBILOG 1022
125