Kipp&Zonen COMBILOG Data Logger - Manual (Page 146)

12.5 Data Logger
This page gives a short overview of the logger configuration.
Settings like general sample rate (for all channels but the ana-
logue channels, minimum and maximum analogue channel
sample rate, average interval and zoom interval are displayed.
In addition the format characters for the logger data file are dis-
played.
12.6 Configuration / Login
By selecting the link “Configuration” the configuration pages will
be entered. Before you can access the configuration pages you
have to enter the password, which is set for the data logger. If
no password is specified you have to enter '000000'.
12.7 Single Channel Configuration
This page gives an overview of the active analogue channel
configuration and allows changing the sample rate for each
single analogue channel.
To change the sample rate for an analogue channel one has to
select the channel in the channel select drop down box and the
desired sample rate in the sample rate drop down box. Press-
ing the 'Save' button saves the configuration.
12.8 Power Switch
On this page the switch-able supply outputs can be configured.
For each of the two switches an analogue channel and a lead
time can be configured.
12.9 Serial Channel
The serial output channel for EIA-232 and EIA-485 can be ac-
tivated or deactivated on this page. If the serial channel is ac-
Hardware Manual COMBILOG 1022 146