Kipp&Zonen COMBILOG Data Logger - Manual (Page 13)

For applications like outdoor use there is a version with stain-
less steel housing available, as well as various other accessor-
ies.
Configuring of the data logger is accomplished by means of an
easy to handle WINDOWS
TM 98 / ME / NT / 2000 / XP software.
2.2 Range of Application
As described under (2.1), the most varying measurement tasks
can easily be accomplished by means of the COMBILOG 1022.
Some typical applications are e.g. measurement of temperat-
ure via resistance thermometers (Pt100), operation with com-
bined sensors with current- or voltage output (e.g. wind speed
measurement with DC generator) or position measurement and
weight measurement by displacement transducers and force
transducers. With these applications the data logger
COMBILOG 1022 supports measuring methods with 2-, 3- and
4-wire technique. The signal processing required in accordance
with the sensors used, such as gain, linearisation, offset cor-
rection etc. can be adjusted individually by software. An extern-
al amplifier is not required.
The digital signal inputs can be used, for example, to connect
switches, initiators, digit emitters and oscillators. Thus status
indications can be collected and tasks like e.g. position meas-
urements, displacement measurements, angular measure-
ments, frequency measurements and timings can be carried
out. Furthermore special 8-bit-Graycode-transmitters can be
connected.
Special calculations of measured values are possible by arith-
metic channels. In case the 8 analogue and 6 digital inputs are
not sufficient, other modules can be connected to the data
Hardware Manual COMBILOG 1022
13