Interlogix NS3702-24P-4S User Manual - Manual (Page 94)

94
 Distance(m) Display the supports distance of current SFP module, the distance value is get
from the SFP module.
 Temperature(C)
– SFP DDM Module Only
Display the temperature of current SFP DDM module, the temperature value is
get from the SFP DDM module.
 Voltage(V)
– SFP DDM Module Only
Display the voltage of current SFP DDM module, the voltage value is get from the
SFP DDM module.
 Current(mA)
– SFP DDM Module Only
Display the Ampere of current SFP DDM module, the Ampere value is get from
the SFP DDM module.
 TX power(dBm)
– SFP DDM Module Only
Display the TX power of current SFP DDM module, the TX power value is get
from the SFP DDM module.
 RX power(dBm)
– SFP DDM Module Only
Display the RX power of current SFP DDM module, the RX power value is get
from the SFP DDM module.
Buttons
SFP Monitor Event Alert: send trap
Warning Temperature: degrees C
Check SFP Monitor Event Alert box; it will be in accordance with your warning temperature setting and allows users to record
message out via SNMP Trap.
Auto-refresh : Check this box to enable an automatic refresh of the Page at regular intervals.
: Click to apply changes
: Click to undo any changes made locally and revert to previously saved values.
: Click to refresh the Page immediately.
4.4.5 Port Mirror
Configure port Mirroring on this Page. This function provide to monitoring network traffic that forwards a copy of each incoming or
outgoing packet from one port of a network Switch to another port where the packet can be studied. It enables the manager to keep
close track of switch performance and alter it if necessary.
 To debug network problems, selected traffic can be copied, or mirrored, to a mirror port where a frame analyzer can be
attached to analyze the frame flow.
 The Managed Switch can unobtrusively mirror traffic from any port to a monitor port. You can then attach a protocol analyzer or
RMON probe to this port to perform traffic analysis and verify connection integrity.