beautypg.com

7 spanning tree protocol, 1 theory – Interlogix NS3702-24P-4S User Manual User Manual

Page 142

background image

142

4.7 Spanning Tree Protocol

4.7.1 Theory

The Spanning Tree protocol can be used to detect and disable network loops, and to provide backup links between switches,

bridges or routers. This allows the switch to interact with other bridging devices in your network to ensure that only one route exists

between any two stations on the network, and provide backup links which automatically take over when a primary link goes down.

The spanning tree algorithms supported by this switch include these versions:

STP – Spanning Tree Protocol (IEEE 802.1D)

RSTP – Rapid Spanning Tree Protocol (IEEE 802.1w)

MSTP – Multiple Spanning Tree Protocol (IEEE 802.1s)

The IEEE 802.1D Spanning Tree Protocol and IEEE 802.1w Rapid Spanning Tree Protocol allow for the blocking of links between

switches that form loops within the network. When multiple links between switches are detected, a primary link is established.

Duplicated links are blocked from use and become standby links. The protocol allows for the duplicate links to be used in the event

of a failure of the primary link. Once the Spanning Tree Protocol is configured and enabled, primary links are established and

duplicated links are blocked automatically. The reactivation of the blocked links (at the time of a primary link failure) is also

accomplished automatically without operator intervention.

This automatic network reconfiguration provides maximum uptime to network users. However, the concepts of the Spanning Tree

Algorithm and protocol are a complicated and complex subject and must be fully researched and understood. It is possible to cause

serious degradation of the performance of the network if the Spanning Tree is incorrectly configured. Please read the following

before making any changes from the default values.

The Switch STP performs the following functions:

Creates a single spanning tree from any combination of switching or bridging elements.

Creates multiple spanning trees – from any combination of ports contained within a single switch, in user specified

groups.

Automatically reconfigures the spanning tree to compensate for the failure, addition, or removal of any element in the

tree.

Reconfigures the spanning tree without operator intervention.

Bridge Protocol Data Units

For STP to arrive at a stable network topology, the following information is used:

The unique switch identifier

The path cost to the root associated with each switch port

The port identifier