Interlogix NS3702-24P-4S User Manual - Manual (Page 237)

237
choose this value. A field for entering an IP protocol filter appears.
■ ICMP : Select ICMP to filter IPv4 ICMP protocol frames. Extra fields for
defining ICMP parameters will appear. These fields are explained later in
this help file.
■ UDP : Select UDP to filter IPv4 UDP protocol frames. Extra fields for
defining UDP parameters will appear. These fields are explained later in
this help file.
■ TCP : Select TCP to filter IPv4 TCP protocol frames. Extra fields for defining
TCP parameters will appear. These fields are explained later in this help
file.
 IP Protocol Value When "Specific" is selected for the IP protocol value, you can enter a specific
value. The allowed range is 0 to 255. A frame that hits this ACE matches this IP
protocol value.
 IP TTL Specify the Time-to-Live settings for this ACE.
■ zero : IPv4 frames with a Time-to-Live field greater than zero must not be
able to match this entry.
■ non-zero : IPv4 frames with a Time-to-Live field greater than zero must be
able to match this entry.
■ Any : Any value is allowed ("don't-care").
 IP Fragment Specify the fragment offset settings for this ACE. This involves the settings for the
More Fragments (MF) bit and the Fragment Offset (FRAG OFFSET) field for an
IPv4 frame.
■ No : IPv4 frames where the MF bit is set or the FRAG OFFSET field is
greater than zero must not be able to match this entry.
■ Yes : IPv4 frames where the MF bit is set or the FRAG OFFSET field is
greater than zero must be able to match this entry.
■ Any : Any value is allowed ("don't-care").
 IP Option Specify the options flag setting for this ACE.
■ No : IPv4 frames where the options flag is set must not be able to match
this entry.
■ Yes : IPv4 frames where the options flag is set must be able to match this
entry.
■ Any : Any value is allowed ("don't-care").
 SIP Filter Specify the source IP filter for this ACE.
■ Any : No source IP filter is specified. (Source IP filter is "don't-care".)
■ Host : Source IP filter is set to Host. Specify the source IP address in the
SIP Address field that appears.