beautypg.com

Interlogix NS3702-24P-4S User Manual User Manual

Page 143

background image

143

STP communicates between switches on the network using Bridge Protocol Data Units (BPDUs). Each BPDU contains the following

information:

The unique identifier of the switch that the transmitting switch currently believes is the root switch

The path cost to the root from the transmitting port

The port identifier of the transmitting port

The switch sends BPDUs to communicate and construct the spanning-tree topology. All switches connected to the LAN on which the

packet is transmitted will receive the BPDU. BPDUs are not directly forwarded by the switch, but the receiving switch uses the

information in the frame to calculate a BPDU, and, if the topology changes, initiates a BPDU transmission.

The communication between switches via BPDUs results in the following:

One switch is elected as the root switch

The shortest distance to the root switch is calculated for each switch

A designated switch is selected. This is the switch closest to the root switch through which packets will be forwarded to

the root.

A port for each switch is selected. This is the port providing the best path from the switch to the root switch.

Ports included in the STP are selected.

Creating a Stable STP Topology

It is to make the root port a fastest link. If all switches have STP enabled with default settings, the switch with the lowest MAC

address in the network will become the root switch. By increasing the priority (lowering the priority number) of the best switch, STP

can be forced to select the best switch as the root switch.

When STP is enabled using the default parameters, the path between source and destination stations in a switched network might

not be ideal. For instance, connecting higher-speed links to a port that has a higher number than the current root port can cause a

root-port change.

STP Port States

The BPDUs take some time to pass through a network. This propagation delay can result in topology changes where a port that

transitioned directly from a Blocking state to a Forwarding state could create temporary data loops. Ports must wait for new network

topology information to propagate throughout the network before starting to forward packets. They must also wait for the packet

lifetime to expire for BPDU packets that were forwarded based on the old topology. The forward delay timer is used to allow the

network topology to stabilize after a topology change. In addition, STP specifies a series of states a port must transition through to

further ensure that a stable network topology is created after a topology change.

Each port on a switch using STP exists is in one of the following five states:

Blocking

– the port is blocked from forwarding or receiving packets

Listening

– the port is waiting to receive BPDU packets that may tell the port to go back to the blocking state

Learning

– the port is adding addresses to its forwarding database, but not yet forwarding packets

Forwarding

– the port is forwarding packets