beautypg.com

Interlogix NS3702-24P-4S User Manual User Manual

Page 402

background image

402

TELNET is an acronym for TELetype NETwork. It is a terminal emulation protocol that uses the Transmission Control

Protocol (TCP) and provides a virtual connection between TELNET server and TELNET client.

TELNET enables the client to control the server and communicate with other servers on the network. To start a Telnet

session, the client user must log in to a server by entering a valid username and password. Then, the client user can enter

commands through the Telnet program just as if they were entering commands directly on the server console.

TFTP

TFTP is an acronym for Trivial File Transfer Protocol. It is transfer protocol that uses the User Datagram Protocol (UDP)

and provides file writing and reading, but it does not provides directory service and security features.

ToS

ToS is an acronym for Type of Service. It is implemented as the IPv4 ToS priority control. It is fully decoded to determine

the priority from the 6-bit ToS field in the IP header. The most significant 6 bits of the ToS field are fully decoded into 64

possibilities, and the singular code that results is compared against the corresponding bit in the IPv4 ToS priority control bit

(0~63).

TLV

TLV is an acronym for Type Length Value. A LLDP frame can contain multiple pieces of information. Each of these pieces

of information is known as TLV.

TKIP

TKIP is an acronym for Temporal Key Integrity Protocol. It used in WPA to replace WEP with a new encryption algorithm.

TKIP comprises the same encryption engine and RC4 algorithm defined for WEP. The key used for encryption in TKIP is

128 bits and changes the key used for each packet.

U

UDP

UDP is an acronym for User Datagram Protocol. It is a communications protocol that uses the Internet Protocol (IP) to

exchange the messages between computers.

UDP is an alternative to the Transmission Control Protocol (TCP) that uses the Internet Protocol (IP). Unlike TCP, UDP

does not provide the service of dividing a message into packet datagrams, and UDP doesn't provide reassembling and

sequencing of the packets. This means that the application program that uses UDP must be able to make sure that the

entire message has arrived and is in the right order. Network applications that want to save processing time because they

have very small data units to exchange may prefer UDP to TCP.