ClearOne comm CONVERGE SR 1212 - Manual (Page 9)

4
ImPORTANT SAFETy INFORmATION
Read all safety information before using this product.
read these instructions. 1.
Keep these instructions. 2.
heed all warnings. 3.
Follow all instructions. 4.
Do not use this apparatus near water. 5.
Clean only with dry cloth. 6.
Do not block any ventilation openings. Install in accordance with the manufacturer’s instructions. 7.
Do not install near any heat sources such as radiators, heat registers, stoves, or other apparatus (including 8.
amplifiers) that produce heat.
Do not defeat the safety purpose of the polarized or grounding-type plug. a polarized plug has two blades
9.
with one wider than the other. a grounding type plug has two blades and a third grounding prong. the wide
blade or the third prong are provided for your safety. If the provided plug does not fit into your outlet, consult
an electrician for replacement of the obsolete outlet. apparatet skal tilkoples jordet stikkontakt.
protect the power cord from being walked on or pinched particularly at plugs, convenience receptacles, and
10.
the point where they exit from the apparatus.
only use attachments/accessories specified by the manufacturer.
11.
use only with the cart, stand, tripod, bracket, or table specified by the manufacturer, or sold with the 12.
apparatus. When a cart is used, use caution when moving the cart/apparatus combination to avoid injury
from tip-over.
unplug this apparatus during lightning storms or when unused for long periods of time.
13.
refer all servicing to qualified service personnel. servicing is required when the apparatus has been 14.
damaged in any way, such as power-supply cord or plug is damaged, liquid has been spilled or objects have
fallen into the apparatus, the apparatus has been exposed to rain or moisture, does not operate normally, or
has been dropped.
use the mains plug to disconnect the apparatus from the aC mains. the mains plug shall remain readily
15.
operable.
on/off switch located on the front panel of the Converge pro 880ta and sr 1212a does not disconnect
16.
power from the aC mains.
to completely disconnect unit power from the aC mains, disconnect the unit’s power cord from the mains
17.
socket. to reconnect power, plug the unit’s power cord into the mains socket following all safety instructions
and guidelines.
Caution: Danger of explosion if lithium battery is incorrectly displaced. replace only with the same or
18.
equivalent type. Battery should only be replaced by qualified personnel and is not intended as a user
serviceable part. Do not expose batteries or battery pack to excessive heat such as prolonged sunlight, fire
or other heat sources.
never push objects of any kind into this product through cabinet slots as they may touch dangerous voltage
19.
points or short out parts that could result in fire or electric shock.
this product can interfere with electrical equipment such as tape recorders, tv sets, radios, computers and
20.
microwave ovens if placed in close proximity.
Class 2 Wiring
21. Is requIreD for these devices. Wiring and install should only be performed by qualified
personnel.
AVIS: RISQUE DE CHOC
ELECTRIQUE - NE PAS OUVRIR
Save These Instructions