ClearOne comm CONVERGE SR 1212 - Manual (Page 119)

114
the Gain slider changes the gain for the telco receive channel from nominal 0. to change the value, use the slider
or the selector box. range is from -65 to +20dB in .5dB increments. the default is 0dB.
min/max Limits
use the yellow and green upper and lower limit arrows on the Gain Scale in the Gain section of the screen to set
minimum and maximum gain level limits. these limits only apply when using relative gain commands; absolute gain
commands can exceed the min and max limits. min/max limits apply to all serially connected control devices and
prevent users from adjusting levels beyond the specified levels.
Post-Gain meter
the Post Gain level meter displays the post-gain signal level in dB.
Channel Routing matrix
the channel routing matrix section of the Channel screen shows the associated matrix row and audio routing
configuration for the selected input channel (telco rx in this case). Clicking a cross point box selects it, clicking
it a second time sets the cross point, as indicated by a green box. the dB level for set cross points is shown
numerically in the box.
For telco rx channels, Outputs 5-8, Speaker, and To Exp. Bus S are selected as cross points by default. you can
click directly on any cross point box in the top row to a cross point (routing path), or leave it blank, as required for
your installation.
to adjust cross point gain/attenuation, right-click on a cross point box and select Cross Point from the shortcut
menu.