ClearOne comm CONVERGE SR 1212 - Manual (Page 308)

303
appenDIx D: ComplIanCe
FCC PART 15/ICES-003 COmPLIANCE
this equipment has been tested and found to comply with the limits for a Class a digital device, pursuant to part 15
of the FCC rules and Industry Canada ICes-003. these limits are designed to provide reasonable protection against
harmful interference when the equipment is operated in a commercial environment. this equipment generates,
uses, and can radiate radio frequency energy and, if not installed and used in accordance with the instruction
manual, may cause harmful interference to radio communications. operation of this equipment in a residential area
is likely to cause harmful interference, in which case the user will be required to correct the interference at his/her
own expense.
this device complies with part 15 of the FCC rules. operation is subject to the following two conditions: (1) this
device may not cause harmful interference, and (2) this device must accept any interference received including
interference that may cause undesired operation.
Changes or modifications not expressly approved by Clearone Communications could void the user’s authority to
operate the equipment.
FCC PART 68 COmPLIANCE
us:FBIBr00BConvpro
ringer equivalence number (ren): 0.0B(ac)
this equipment complies with part 68 of the FCC rules requirements adopted by aCta. on the mixer unit of this
equipment contains, among other information, a product identifier in the format us:aaaeq##txxxx. If requested,
this information must be provided to your telephone company.
the ren is used to determine the number of devices that may be connected to the telephone line. excessive rens
on the telephone line may result in the devices not ringing in response to an incoming call. In most, but not all areas,
the sum of the rens should not exceed five (5.0). to be certain of the number of devices that may be connected
to the line, as determined by the total rens, contact the telephone company to obtain the maximum rens for the
calling area. the ren for this product is part of the product identifier that has the format us:aaaeq##txxxx. the
digits represented by ## are the ren without a decimal point (e.g. 03 is a ren of 0.3).
If this equipment causes harm to the telephone network, the telephone company will notify you in advance that
temporary discontinuance of service may be required. But if advance notice isn’t practical, the telephone company
will notify the customer as soon as possible. also, you will be advised of your right to file a complaint with the FCC if
you believe it is necessary.
the telephone company may make changes in its facilities, equipment, operations, or procedures that could affect
the operation of the equipment. If this happens, the telephone company will provide advance notice in order for you
to make the necessary modifications to maintain uninterrupted service.
this equipment uses an rJ11C jack that is used to connect this equipment to the premises wiring and telephone
network. this rJ11C jack complies with the applicable FCC part 68 rules and requirements adopted by the aCta.
a compliant telephone cord and modular plug is provided with this product. It is designed to be connected to a
compatible modular jack that is also compliant. see installation instructions for details.
wARNING: the country code must be set correctly in Console to ensure that the unit operates properly
when connected to the telco network, and that it complies with the country’s telco requirements.
Changing this code to a country other than the intended country of operation might cause Converge pro
devices to be non-compliant.