ClearOne comm CONVERGE SR 1212 - Manual (Page 272)

267
RxBSTEN – Receive Boost Enable
this command selects/reports the receive boost status.
Command Form : DEVICE RxBSTEN [value]
Argument Type Size Values units
Channel Channel 1 see Groups and Channels
group group 1 17 (r)
value unsigned Integer 2 0 = off
1 = on
2 = toggle
(null to query in text)
SERECHO – Serial Echo
this command selects/reports the serial echo of the rs-232 port.
Command Form : DEVICE SERECHO [value]
Argument Type Size Values units
value unsigned Integer 4 0 = off
1 = on
2 = toggle
(null to query in text)
NOTE: the unit will return the updated state of the last selection in the same form as the
command.
SFTymuTE – Safety Mute
this command selects/reports the state of the safety mute. safety mute holds all outputs in a muted state. It used
for syncing to a site document to avoid feedback or blown speakers until the unit is in a settled state.
Command Form : DEVICE SFTymuTE [value]
Argument Type Size Values units
value Channel 4 0 = off
1 = on
2 = toggle
(null to query in text)
SIGGEN – Signal Generator
this command selects/reports of the signal generator activation.
Command Form : DEVICE SIGGEN [Channel group type amplitude Frequency]
Argument Type Size Values units
Channel Channel 1 see Groups and Channels
(null to query in text)
group group 1 1, 3, 7 (I, m, l)
type unsigned Integer 2 1 = pink noise
2 = White noise
3 = tone
amplitude signed Float 4 -60.00 – 20.00 dB
Frequency unsigned Float 4 type 1 – 2 0 (null in text) hz
type 3 20.00 – 20000.00
SIGGENEN – Signal Generator Enable
this command selects/reports of the signal generator activation.
Command Form : DEVICE SIGGENEN [value]
Argument Type Size Values units
value unsigned Integer 4 0 = off
1 = on
2 = toggle
(null to query in text)