ClearOne comm CONVERGE SR 1212 - Manual (Page 123)

118
mute Button
Clicking the mute button toggles muting. the default is off.
Gain Slider
the Gain slider adjusts the output gain level. to change the value, use the slider or selector box. range is from -65
to +20dB in .5dB increments. the default is 0dB.
min/max Limits
use the yellow and green upper and lower limit arrows on the Gain Scale in the Gain section of the screen to set
minimum and maximum gain level limits. these limits only apply when using relative gain commands; absolute gain
commands can exceed the min and max limits. min/max limits apply to all serially connected control devices and
prevent users from adjusting levels beyond the specified levels.
Output Level meter
shows the signal level in dB when a signal is present.
Channel Routing matrix: Outputs
the channel routing matrix shows the matrix row and audio routing configuration for the selected channel (output
1 in this case). Clicking a cross point box selects it, clicking it a second time sets the cross point, as indicated by a
green box. the dB level for set cross points is shown numerically in the box.
you can click directly on any cross point box in the top row to set a parameter as cross point, or leave it blank,
as required for your installation. to adjust cross point gain/attenuation, right-click on a cross point box and select
Cross Point from the shortcut menu.