Checkline TI-CMXDLP - Manual (Page 32)

– 32 –
5.3 Factory Setup Chart
Num Name Comment 1 Gn/AGC Velocity
1 Enter Custom Name
2
3
4
5
6
– 73 –
3. Use the LEFT and RIGHT arrow keys to toggle the ALARM on/off/audible.
4. Continue on to the next section “Setting the Alarm Low Limit”.
Setting the Low Alarm Limit
1. Assuming the ALARM is ON, use
the UP and DOWN arrow keys to
scroll through the sub menu items
until ALARM LOW is highlighted.
2. Press the LEFT and RIGHT arrow
keys to scroll the value. When
the correct alarm value is being
displayed, proceed to step 7 .
3. Alternatively, press the ENTER
key to display the Digits Edit Box.
4. Press the UP and DOWN arrow
keys to scroll the highlighted value.
5. Press the LEFT and RIGHT arrow
keys to scroll the digit locations.
6. Repeat steps 4 & 5 until the
ALARM LOW value is correctly
displayed.
7. If only one limit will be used,
press the MEAS key to return
to the measurement screen and
begin taking readings. Otherwise,
continue on to set the ALARM
HIGH limit using the same
procedures.