Pilz PSENvip RL D P - Manual (Page 65)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
4-37
4.7 System cycle
4 Function description
4.7.3 System cycle for back gauge press stroke
System cycle for back gauge press stroke 4- Funktion_Systemablauf_Pressenhub_mit_Anschlag
Inputs on the PSENvip receiver:
 Protected field mode 1 = 1
 Protected field mode 2 = 0
 Acknowledgement of reduced protected field = Press pushbutton
and then release
The system cycle is the same as for box bending. Please note that with
back gauge protected field mode, the rear segments of the protected
field are blanked.
4.7.4 System cycle for box bending with back gauge press stroke
System cycle for box bending with back gauge press stroke 4- Funktion_Systemablauf_Pressenhub_Kastenbiegen_mit_Anschlag
Inputs on the PSENvip receiver:
 Protected field mode 1 = 1
 Protected field mode 2 = 1
 Acknowledgement of reduced protected field = Press pushbutton
and then release
The system cycle is the same as for box bending. Please note that with
box bending with back gauge protected field mode, both the front and
rear segments of the protected field are blanked.