Pilz PSENvip RL D P - Manual (Page 107)

Pilz GmbH & Co. KG, Felix-Wankel-Straße 2, 73760 Ostfildern, Germany
Telephone: +49 711 3409-0, Telefax: +49 711 3409-133, E-Mail: [email protected]
7-25
7.5 Check protective equipment
7 Commissioning
The test piece interrupts the advance measuring field. The press stroke
is stopped. The upper tool should not touch the test piece.
 Once the press stroke has stopped, push the 15 mm high section of
the test piece beneath the upper tool.
The upper tool should not touch the test piece.
Function test using the 35 mm test piece
 Start up the press.
 Position the 35 mm high section of the test piece on top of the lower
tool.
 Initiate a press stroke.
The test piece interrupts the advance measuring field. The press stroke
is stopped. The upper tool should not touch the test piece.
7.5.2 Visual inspection
Visual inspection 7- Inbetriebnahme_Schutzeinrichtung_pruefen_Sichtpruefung
Check the following on the PSENvip transmitter and receiver
 The condition of the installation and attachment
 Any damage on the housing and lens
 Electrical connections
 Switch on the machine.
 Check the messages on the display.