Welch Allyn Connex Integrated Wall System - User Manual - Manual (Page 83)

1. On the Home tab, touch the interval timer button ( ).
2. Touch Stop intervals.
Cancel a measurement that is in progress
Follow these steps to cancel any NIBP measurement that is in progress.
On the Home tab, touch .
The monitor rapidly deflates the cuff, and the screen displays the NIBP cancellation message.
If intervals are turned on, the button changes to a timer ( ), which counts
down to the next automatic measurement.
Configure NIBP alarms
Follow these steps to set alarm limits for systolic and diastolic measurements, and MAP
calculation.
1. Verify that you are using the Monitor profile, which contains the Alarms tab.
2. Touch the Alarms tab.
3. Touch the NIBP tab.
4. Enter the desired upper and lower alarm limits for systolic and diastolic measurements, and
MAP calculation using the up/down arrow keys or the keypad.
5. Touch the Home tab.
The new alarm settings display in the Alarm Limit control button.
Temperature
Temperature frame
From the temperature frame you can measure patient temperature.
Located in the lower right corner of the Home tab, the temperature frame contains data and
features relevant to temperature measurement. The frame provides different features based on the
profile you are using.
Temperature frame in Monitor profile
Directions for use Patient monitoring 77