Welch Allyn Connex Integrated Wall System - User Manual - Manual (Page 42)

Select a language
When you power up the wall system for the first time, the language selection screen appears.
1. Select your language.
2. Touch Exit.
The Home tab appears.
Set the date and time
1. Touch the Settings tab.
2. Touch the Device tab.
3. Touch the Date/Time vertical tab.
4. To change the date and time values: Touch the up and down arrow keys or touch and
enter a value.
Repeat for each value you want to change.
Note
The date and time stamps on saved patient measurements will
adjust in response to new date and time settings.
Enter clinician information
1. Go to the Clinician tab using one of these methods:
• Touch the Clinician ID section (left edge) of the Device Status area on the Home tab.
• Touch the Settings tab and then touch the Clinician tab.
2. To enter the clinician name, touch , located at the right of the text field, and enter
characters.
You can enter up to 32 characters for the clinician's first and last name. Enter only 1 character
for the middle initial.
3. To enter the clinician ID, use one of these methods:
36 Startup Welch Allyn Connex ® Integrated Wall System