Welch Allyn Connex Integrated Wall System - User Manual - Manual (Page 137)

4. Select up to four parameters and associated units of measure for display in the Manual
Parameters frame.
If the monitor has the SureTemp Plus temperature module, the Temperature parameter is
not available here or in the Manual Parameters frame.
5. Do one of the following:
• To continue in the Advanced Settings, touch another tab.
• To exit the Advanced Settings and return to the Home tab, touch Exit.
Data management
Specify patient ID settings
Patient identification appears on the Home tab in the Patient frame, and it is listed in various tabs,
such as the Patient tab and the Review tab.
1. Access the Advanced Settings.
a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.
2. Touch the Data Management tab.
3. Touch the Patient IDs tab.
4. Specify settings.
Setting Action/Description
Name format Select a format for all displayed patient names:
Full name or Abbreviation.
Primary label Select the primary identification label for all
displayed patients.
Secondary label Select a secondary identification label for patients.
A secondary label displays only on the Home tab,
after the primary label.
Directions for use Advanced settings 131