beautypg.com

Specify advanced spo2 settings, Specify advanced sphb settings – Welch Allyn Connex Integrated Wall System - User Manual User Manual

Page 135

background image

clinicians remove the temperature probe from the

well.
Select

Last Site

to set the default to the site

selected for the last measurement.

5. Do one of the following:

To continue in the Advanced Settings, touch another tab.

To exit the Advanced Settings and return to the Home tab, touch Exit.

Specify advanced SpO2 settings

1. Access the Advanced Settings.

a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.

2. Touch the Parameters tab.
3. Touch the SpO2 tab.
4. Specify settings.

Setting

Action/Description

Default view

Select a numeric view or a waveform view as the

primary SpO2 display on the Home tab.

Default response

Select the default speed of response to changes in

SpO2 measurements.

Sweep speed

Select the waveform sweep speed for the SpO2

display in the Home tab.

5. Do one of the following:

To continue in the Advanced Settings, touch another tab.

To exit the Advanced tabs and return to the Home tab, touch Exit.

Specify advanced SpHb settings

1. Access the Advanced Settings.

a. Touch the Settings tab.
b. Touch the Advanced tab.
c. Enter the Advanced settings code.
d. Touch OK.
The General tab appears.

2. Touch the Parameters tab.
3. Touch the SpHb tab.
4. Specify settings.

Setting

Action/Description

Reference

Select arterial or venous as the calibrated

reference source.

Directions for use

Advanced settings 129