Kontron AT890X Full-Size CLI - Manual (Page 93)

AT8901/2/3 Switching Commands
Page 2 - 59 AT8901/2/3 CLI Reference Manual
Format
no macfilter addsrc all
Mode Global Config
2.14.4 show mac-address-table static
This command displays the Static MAC Filtering information for all Static MAC
Filters. If you select
, all the Static MAC Filters in the system are displayed. If
you supply a value for
,
you must also enter a value for , and the
system displays Static MAC Filter information only for that MAC address and VLAN.
Format
show mac-address-table static { | all}
Mode Privileged EXEC
MAC Address Is the MAC Address of the static MAC filter entry.
VLAN ID
Is the VLAN ID of the static MAC filter entry.
Source Port(s) Indicates the source port filter set's slot and port(s).
2.14.5 show mac-address-table staticfiltering
This command displays the Static Filtering entries in the Multicast Forwarding
Database (MFDB) table.
Format
show mac-address-table staticfiltering
Mode Privileged EXEC
Mac Address A unicast MAC address for which the switch has forwarding and or
filtering information. The format is 6 or 8 two-digit hexadecimal num-
bers that are separated by colons, for example 01:23:45:67:89:AB. In
an IVL system the MAC address will be displayed as 8 bytes.
Type Displays the type of the entry. Static entries are those that are config-
ured by the end user. Dynamic entries are added to the table as a result
of a learning process or protocol.
Description The text description of this multicast table entry.
Interfaces
The list of interfaces that are designated for forwarding (Fwd:) and fil-
tering (Flt:).
2.15 IGMP Snooping Configuration Commands
This section describes the commands you use to configure IGMP snooping.
FASTPATH supports IGMP Versions 1, 2, and 3. The IGMP snooping feature can help
conserve bandwidth because it allows the switch to forward IP multicast traffic only to
connected hosts that request multicast traffic. IGMPv3 adds source filtering
capabilities to IGMP versions 1 and 2.
2.15.1 set igmp
This command enables IGMP Snooping on the system (Global Config Mode) or an
interface (Interface Config Mode). This command also enables IGMP snooping on a
particular VLAN and can enable IGMP snooping on all interfaces participating in a
VLAN.